Monday, November 10, 2008
Step 6: Installing the Motherboard Ensure that the motherboard mounting area in the case is free of obstructions and that all necessary risers have been installed in the right spots. If there is an extra riser that does not line up with a hole in the motherboard, make sure you remove it. Lower the board into the case as in step 2. Screw the motherboard into the risers. Note that some forms of risers will not require screws to be used. You can figure it out. Once the board has been securely attached, plug in the 24 or 20-pin main ATX power connector (see pic). If you are installing an Intel Pentium 4 machine, you will probably be required to connect one or two extra power connectors (see pic). Plug the 4-pin 12V auxiliary power, and 6-pin power connectors in also. Note: some motherboards may not require the 6-pin connector at all. Consult your motherboard manual for the correct locations of the 'front panel' power and reset button wires, the power and hard-drive LED wires and the speaker. Note that the power and hard-drive LED wires are sensitive to polarity, so they will only work one way around. In theory, positive and negative will be indicated on the board and the plugs... In practice, doubtful, so... trial and error. You will not cause any damage if you get it wrong, though, the LEDs will just not light up. 
| © 2008 PCSTATS.com Please respect the time and effort that went into creating each PCSTATS Beginners Guide, do not illegally copy. Thank you. |
0 comments:
Post a Comment